Docomo Prime SH-06A, Instruction Manual, Page: 118 / 589

116
e06_dv65_7e.fm
[116/132]
Security Settings
For convenient use of the FOMA terminal functions, some
functions require security codes. In addition to the terminal
security code used for various handset operations, use security
codes such as the network security code and i-mode password
when using network services. Use security codes with various
functions to fully utilize the FOMA terminal.
Entered terminal security code (security code for each function), network
security code, i-mode password, and PIN1/PIN2 code are masked with
[
|
].
Terminal security code is set to [0000] by default but can be changed by the
user (
n
P. 117).
If the terminal security code is incorrectly entered, [Security code is
wrong] appears. Enter the correct terminal security code.
If the terminal security code is incorrectly entered five times continuously,
the power is turned off.
Network security code is a four-digit code required for confirming the
subscriber’s identity when an order is received at a docomo Shop, docomo
Information Center or “
お客様サポート
(User Support)”, or used for
accessing various network services. The code is set at the time of
subscription and afterwards can be changed by the user.
For those with “docomo ID/password” of the general support site “My
docomo” designed for PC, the registration procedure for a new network
security code is available from PC.
From i-mode, the security code can be changed by the user, accessing “
各
種設定 ( 確認・変更・利用 ) (Various Settings (Checking, Changes, Use))” in
お客様サポート
(User Support).
※ Refer to the inside back cover of this manual for details on “My docomo”
and “
お客様サポート
(User Support)”.
A four-digit “i-mode password” is required to register/delete sites in マイメ
ニュー
(My menu), or subscribe/cancel message services and charged
i-mode services (Additionally, information providers may set their own
passwords).
i-mode password is set to [0000] by default but can be changed by the
user.
From i-mode, the password can be changed by accessing [iMenu]
/
[English]
/
[Options]
/
[Change i-mode Password].
Set two security codes, PIN1 code and PIN2 code, on the FOMA card.
These security codes are set to [0000] by default but can be changed by the
user (
n P. 118).
Security codes used on the FOMA
terminal
Precautions for various security codes
Do not use easily estimated numbers for security codes to be set such
as “birthday”, “part of a phone number”, “address or room number”,
“1111” or “1234”. Keep a separate memo of security codes.
Keep security codes private. If the security codes are found and
improperly used by others, DOCOMO shall not be liable for any loss of
the users.
When security codes are lost, the FOMA terminal owner will be asked
to bring an identification (a driver’s license, etc.), a FOMA terminal and
a FOMA card to a docomo Shop.
For further details, contact the number listed in “General Inquiries” on
the back of this manual.
Terminal security code (for various functions)
Network security code
i-mode password
PIN1 code/PIN2 code
dv65_E.book 116 ページ ２００９年５月７日 木曜日 午前９時３分