Docomo FOMA P706ie, Instruction Manual, Page: 97 / 577

95
S
o
un
d/
Sc
re
en
/L
ig
ht
Se
tt
in
gs
The confirmation tone sounds twice when charging starts/ends.
1 m 1
Settings
1
Other settings
1
Battery
1
Charge sound
1
ON or OFF
When a call is likely to be disconnected midway due to bad radio wave
conditions, an alarm sounds to inform you right before disconnection.
1 m 1
Settings
1
Talk
1
Quality alarm
1
Select an alarm.
No tone . . . . . Does not sound.
High tone . . . High alarm sounds.
Low tone . . . . Low alarm sounds.
<Charge Sound>
Setting Charging-start/end Tones
Information
≥
You cannot change the volume for charge sound.
≥
The charging confirmation tone does not sound when a display other than the
Stand-by display is shown or during Manner Mode or Public Mode (Drive Mode).
+ m - 7 - 5
<Quality Alarm>
Sounding Alarm when a Line is Likely to
be Disconnected
Information
≥
You might be disconnected without hearing an alarm if radio wave conditions
deteriorate suddenly.
≥
An alarm for “Quality alarm” sounds only from the earpiece during a videophone call.
You can set the duration of the ring tone which sounds for incoming
i-mode mail, SMS messages, Chat mail and Messages R/F.
1
m
1
Settings
1
Sound
1
Mail/Msg. ring time
1
Select a type of mail or message
1
ON or OFF
1
Enter a ring time (seconds).
≥
Enter in two digits from “01” through “30”.
You can set where you make the ring tone and alarm sound from for
when you connect the Flat-plug Earphone/Microphone with Switch
(option).
1 m 1
Settings
1
Sound
1
Headset usage setting
1
Headset and speaker or Headset only
+ m - 6 - 8
<Mail/Message Ring Time>
Setting Ring Time for Mail and Messages R/F
+ m - 5 - 1
<Headset Usage Setting>
Sounding Ring Tone from Earphone Only
Information
≥
Even when you set “Headset only”, the ring tone sounds from both the earphone and
speaker about 20 seconds after ringing starts. However, the tone does not sound from
the speaker but sounds from the earphone only even after 20 seconds have elapsed if
the tone sounds for the operations other than incoming calls, incoming mail, and
alarm notification.
≥
Even when you set “Headset only”, the tone sounds from the speaker when you do
not connect the Flat-plug Earphone/Microphone with Switch or when you start
shooting still or moving images.