Docomo FOMA P706ie, Instruction Manual, Page: 67 / 577

65
V
oic
e
/V
id
e
op
ho
ne
C
a
lls
1
m
1
Settings
1
Talk
1
Volume
1
Use
B o
or
<
/
>
to
adjust the earpiece volume.
Adjust the earpiece volume to Level 1 (minimum) through Level 6 (maximum).
≥
During a call or calling, you can press
B o
or
<
/
>
to adjust the volume, and
while entering phone number, you can press and hold
B o
(for at least one
second) to adjust it. Press
B o
or
<
/
>
within two seconds to adjust it.
Information
≥
This function is disabled when you set “Headset mic. setting” to “Headset
microphone” and the Flat-plug Earphone/Microphone with Switch (option) is
connected. The communication state does not change even if you close the FOMA
phone during a voice call. If you close the FOMA phone during a videophone call, the
substitute image is sent to the other party with the line connected.
≥
If you close the FOMA phone during a videophone call with “No tone” set, the
substitute image is sent to the other party. When “Tone on” is set, the still image set
for “Holding” of “Select image” is sent.
≥
If you set to “No tone” or “Tone on”, “Holding” is displayed on the Private window
when the FOMA phone is closed.
<Volume>
Adjusting Earpiece Volume
Information
≥
The earpiece volume adjusted during a call is retained even after the call ends.
≥
When you adjust the earpiece volume, the sound volume during a Hands-free call is
also adjusted.
You can adjust the ring volume for incoming calls and mail.
1 m 1
Settings
1
Sound
1
Ring volume
1
Select an incoming type
1
Use
B o
to adjust the volume.
≥
Following icons are displayed on the Stand-by display while the ring volume is set
to “Silent”:
: The ring volume for voice calls or videophone calls is “Silent”.
: The ring volume for mail, chat mail or Messages R/F is “Silent”.
: The ring volume for voice calls or videophone calls is “Silent” and the ring
volume for mail, chat mail, or Messages R/F is “Silent”.
≥
If you have set “Step”, the ring tone is silent for about three seconds, and then the
volume steps up every three seconds, from Level 1 through Level 6.
≥
During ringing of a voice call or videophone call, you can adjust the ring volume
also by pressing
B o
or by pressing and holding
<
/
>
for at least one second.
However, you cannot adjust the ring volume in the following cases:
・ When Ring Volume is set to “Step”
・ When “Answer setting” is set to “Quick silent” and you stop the ring tone or
voice guidance
・ During Manner Mode
・ When a call is cut off within the ring start time specified by “Ring time”
+ m - 5 - 0
<Ring Volume>
Adjusting Ring Volume