Docomo FOMA N901IC, User Manual, Page: 504 / 596

502
Data Comm
unication
Setting up the access point (APN)
Default setting cid1: mopera.ne.jp
Default setting cid2 to 10: not set
Communication software to enter AT commands is
required for settings. This section describes how to set it up
using “Hyper terminal” that comes with Windows.
● Set up the access point (APN) for packet communication.
You can set up to 10 access points (APN) up by assigning
registration numbers cid1 through cid10 (P. 499).
● Since APN “mopera.ne.jp” to connect to DoCoMo’s internet
connection service “mopera” has already been assigned to
cid1, we recommend that you enter cid into numbers 2
though 10.
● Registered cid will be connection numbers in the dialup
connection settings.
● Contact your internet service provider or network adminis -
trator for any other access point (APN) than mopera.
● The AT commands entered in “Hyper terminal” may not be
shown after Step 6 on P. 503. In this case, if you enter
ATE1
AT commands you enter from then on are shown.
<Example: for Windows XP>
1
Connect the FOMA terminal to the FOMA
USB connection cable.
2
Power the FOMA terminal on and
connect the FOMA USB connection cable
connected with the FOMA terminal with
the PC.
3
Click “
スタート
” (Start)
→
“
すべての
プログラム
” (All programs)
→
“
アク
セサリ
” (Accessories)
→
“
通信
”
(Communication)
→
“
ハイパーターミ
ナル
” (Hyper terminal) to start Hyper
terminal.
For Windows Me, Windows 2000
Open “ スタート ” (Start) → “ プログラム ”
(Programs)
→
“
アクセサリ
” (Accessories)
→
“
通
信 ” (Communication) → “ ハイパーターミナル ”
(Hyper terminal).
For Windows 98
After opening “
ハイパーターミナル
” (Hyper
terminal), double-click “Hypertrm.exe”.
4
Enter any name you want in the “
名前
”
(Name) column and click “OK”.
“sample” is entered here as an example.
5
Select “FOMA N901iC” from “
接続方法
”
(Connection method), tentatively and click
“OK”.
If a COM port of “FOMA N901iC” can be selected
When Properties of the COM port is displayed, click
“OK”.
In this example, “COM3” is selected. See “Checking
the COM port” on P. 499 to confirm the actual COM
port number of “FOMA N901iC” to be selected in “
接
続方法 ” (Connection method).
If no COM port of “FOMA N901iC” can be selected
Click “
キャンセル
” (Cancel) to close the “
接続の
設定 ” (Connection Settings) screen and do the
following settings;
(1) Select “
ファイル ” (File) menu → “ プロパ
ティ
” (Properties).
(2) Select “FOMA N901iC” in the “ 接続方法 ”
(Connection method) column of the “
接続の設
定 ” (Connection Settings) tab on the “sample
のプロパティ (sample Properties)”.