Docomo FOMA N601i, Manual, Page: 61 / 469

58 Making/Receiving Phone Calls
<Sub-address setting>
Setting Sub-addresses When Making Calls
This function enables you to set “
*
” contained in a phone number as a separator so that numbers
following “
*
” are recognized as a sub-address. Sub-addresses are available in ISDN to identify calls
made from specific communication devices or to select contents in “V-live”.
1
i
X “Settings” X “Dialing” X “Sub-address setting” X “ON”
■ To cancel the sub-address setting
X
“OFF”
e
In the following cases, “
*
” does not function as a sub-address separator. A number including “
*
” is recognized as
an ordinary phone number.
a
“
*
” is at the beginning of a phone number.
a “186/184” is followed by “
*
” at the beginning of a phone number.
a
“
*
” follows the number entered in “Prefix numbers”.
a
“
*
590#/
*
591#/
*
592#” is included in a phone number.
<Reconnect signal>
MENU77
Setting the Alarm Used for Reconnection
When the signal quality deteriorates during a voice call or videophone call to the extent that the call
drops out, the FOMA terminal will automatically reconnect the call if the signal quality quickly
improves. This function allows you to set the type of alarm given when a call is being reconnected.
d
The time needed for reconnection varies depending on communication conditions such as manipulation or
signal quality. It may roughly take about 10 seconds.
1
i
X “Settings” X “Talk” X “Reconnect signal” X “No tone”, “High
tone” or “Low tone”
e
A call may drop out without an alarm if signal quality worsens very quickly.
e
Call charges apply in the interval (up to roughly 10 seconds) prior to reconnection.
e The other party hears no sound while the signal is lost.
<Noise reduction>
MENU76
Blocking Out Ambient Noise
Noise reduction is a function that suppresses ambient noise. This makes it easier for the other party in
a voice or videophone call to hear you when you are in a noisy location.
1
i
X
“Settings”
X
“Talk”
X
“Noise reduction”
X
“ON”
■ To not use the noise reduction
X “OFF”
NOTE
NOTE
Default setting
ON
Default setting
High tone
Default setting
ON