Docomo FOMA N601i, Manual, Page: 360 / 469

357 Appendix/External Devices/Troubleshooting
The display is not clearly seen
d
Is the brightness of the backlight set to “Level 1”?
d
Is Privacy angle set to “ON”?
p.123
The backlight of the display does
not turn on
d
Is Lighting of the backlight set to “OFF”?
d
Press and hold
5
for 1 second or longer to turn the backlight on or off.
Note that pressing and holding
5
for 1 second or longer will turn
off the backlight e.g. while composing a message.
p.123
Receiving an incoming call
immediately after turning on the
power displays the phone number
but does not display the name
stored in the phonebook
d
The FOMA terminal may be reading the FOMA card (UIM)
immediately after turning on the power. The phonebook function may
not be available then.
−
It takes some time for the power to
turn on after pressing and holding
y
for 1 second or longer
d
Data checking may take time e.g. if the phonebook is full of data. p.104
The FOMA terminal does not
perform incoming call operations
(ring tone sounding, vibrator,
incoming call lamp flashing) when
receiving a call d The FOMA terminal does not perform incoming call operations (ring
tone sounding, vibrator, incoming call lamp flashing) until the set time
is reached, when receiving a call from a phone number not stored in
the phonebook or from a caller who does not notify his/her caller ID
and if “Set mute seconds” under “Ring time(sec.)” is set to “ON”. p.157
The figure of the accumulated
charge does not increase d The figure does not increase if it has already reached the limit.
Perform “Reset total”. p.297
Receiving an SMS does not
display the sender’s name stored
in the phonebook d Did you correctly store the sender’s phone number on the phone
number line (
) of the phonebook?
p.93
A message is not automatically
filtered d
If the sender’s mail address is “(Phone number) ＠ docomo.ne.jp”,
save only the phone number in the Auto-sort settings.
d
If the sender’s mail address is not “(Phone number) ＠ docomo.ne.jp”,
save the entire address including the domain in the Auto-sort settings.
p.235
A message is not automatically
received
d
If you have set “Receive option setting” to “ON”, set it to “OFF”. p.223
p.242
i-mode, i-mode mail and i-channel
cannot be connected
d
Is “Host selection” set to “i-mode”?
d
If you had started using the FOMA terminal before you subscribed to
i-mode, turn the FOMA terminal off and then turn it back on.
p.194
−
The FOMA terminal does not
perform receiving message
operations (ring tone sounding,
vibrator, incoming call lamp
flashing) when receiving a message
d
Is “Mail/Msg. ring time” set to “OFF”?
d
Is “Receiving display” set to “Operation preferred”?
p.116
p.242
The message “ 添付ファイル削除 ”
(Attached file deleted) appears on
a mail message
d
You cannot receive attached files that are not supported by i-mode
mail. Such attached files are automatically deleted in the i-mode
center and you receive only the message. p.222
I was disconnected while sending a
message, then received an SMS
A message appears when I retry
d
SMS interrupts communication and notifies you that a large amount
of data is being transferred within a given time. Follow the contents
of SMS and the displayed message.
−
A file attached to a message sent
from a PC was deleted
d
If the image file is GIF-formatted, which was attached to a message sent from a
device other than the FOMA terminal, only up to 10,000 bytes can be received.
−
Still images or movies look blurred
d
Set a mode suited to the scene being shot. p.174
Attempting to display an image
displays “ ”
or
Attempting to play for
demonstration or see a preview
displays “ ”
d “ ” may appear when the image data is corrupted.
−
The terminal operates slowly
when any keypads are pressed d It may occur if a large amount of data is stored on the FOMA terminal.
−
Chance capture shooting
shortens the shooting time
d
Chance capture shooting saves control data together with movie
data, which may shorten the shooting time.
−
Problem Points to check Refer to