Docomo FOMA N601i, Manual, Page: 280 / 469

277 Display/Edit/Organization
1
Select “YES” on the message
■ To cancel saving the data
X
“NO”
2
Select a folder X Select data to
delete
Selecting multiple data
→
p.32, 276
3
o
(Finish)
X
“YES”
o
(Finish) does not appear until enough memory
is allocated to save the data.
e
When you attempt to delete an image or movie that
has been set to a screen or a melody that has been
set as a ring tone, a message appears asking
whether to delete the file. If “YES” is selected to
delete the file, the corresponding screen or ring tone
is restored to default.
<Forwarding image>
Preventing Phonebook
Image Forwarding
Prevent still images stored in the phonebook
from being sent when transferring phonebook
data via infrared data exchange or data
exchange (OBEX).
1
i
X “LifeKit” X “Forwarding
image”
X “OFF”
■ To transfer
X
“ON”
<Infrared data exchange/OBEX>
Transferring Data via Infrared Data
Exchange/Cable Connection
The infrared data exchange or cable connection
allows the FOMA terminal to exchange data
such as phonebook entries and received
messages with another FOMA terminal or a PC.
c
The infrared data exchange with another FOMA
terminal or a PC supporting the feature allows
you to transfer one data at a time or multiple data
at the same time. “
” appears during infrared
data exchange.
c Connect the FOMA terminal and a PC via FOMA
USB Cable (optional), and you can receive one
data at a time from the PC via OBEX (protocol
for data communication), or exchange multiple
data at the same time between the FOMA
terminal and the PC. “
” appears while a cable
is connected.
c
You can transfer the following:
a
Received mail
a
Sent mail
a
Draft mail
a
i-mode bookmark
a
Phonebook
a
My Profile data
a
To Do list
a
Text memo
a
Schedule
a
Image
*
a
Movie (i-motion)
*
a
Melody
*
* ： You cannot send all data via infrared data exchange.
Transferring data via
infrared data exchange
c
Set the receiving FOMA terminal to standby, and
keep approximately 20cm or less between the
infrared data ports of the FOMA terminals.
c
Place the FOMA terminals on a stable surface,
such as a table, so that the infrared data ports
are aligned on the same level and facing each
other.
c
Do not move the FOMA terminals during data
exchange.
c Do not place anything between the FOMA
terminals or cover the infrared data ports.
c
If data exchange is finished unsuccessfully,
adjust the positions then retry the exchange.
c
The FOMA terminals may not communicate
successfully if they are placed under direct
sunlight, directly under a fluorescent light, or
close to other infrared equipment.
Transferring data via cable
connection
c To transfer data, you need the software such as
DoCoMo keitai datalink.
“DoCoMo keitai datalink”
→ p.322
NOTE
Default setting
ON
Appro
ximater
y
20cm or less
Infrared data
port
Within the
range of ±15º
Continued on next page