Docomo FOMA D905I, Manual

Page: 41 / 513

39 Before Using the Handset
1
m z
Settings & NW services
z 79
9
･
The subsequent steps are the same as when
setting upon turning the power on for the first time.
INFORMATION
● When you turn the power on during All Lock or Keypad
Dial Lock or when the power is turned on by Auto Power
ON, the initial setting screen does not appear.
●
The settings of this function are reflected to each function
settings.
Switching to English display
Select Language
1
m z
Settings & NW services
z 27
3 z 1
or
2
INFORMATION
●
This setting is saved in the UIM.
Setting the date and time
Date and Time Setting
The time setting can be performed in two ways:
automatically adjusting the time and time difference of
the FOMA terminal, or manually entering the current
time to the terminal.
1
m z
Settings & NW services
z 71
1 z
Set each item
z p
The time and time difference are corrected
automatically when the UIM is inserted and you turn
the power on in a location where radio waves reach.
･
The automatic correction sometimes causes a time
error of several seconds. In addition, it may fail to
correct depending on the signal condition.
･
If the time information is received while i-
α
ppli is
running, the time may not be corrected depending on
the i-
α
ppli.
･
Even when
Auto time adjust
is set to
ON
, the time may
not be corrected for a while. To enable the automatic
correction, turn the power off and then on.
･
When no UIM is inserted or the FOMA terminal is out
of the service area, the automatic correction is not
performed even if you turn the power off and then on.
･
When the time difference is adjusted while you stay
overseas, dates and times of the calls dialed/
received and of the mails sent/received after that are
recorded and displayed in the local time.
･
Depending on the network of the service provider that
you are using overseas, the time difference may not
be adjusted.
･
If
Auto time adjust
of this setting and Two Time Zone
Clocks are set to
ON
, when you receive the
information to adjust the time difference from the
network of the connected service provider overseas,
the two time zone clocks appear on the standby
display.
INFORMATION
●
You cannot use the following functions when the date
and time are not set:
･
Auto Power ON/OFF
･
Alarm Clock
･
Machi-chara
･
i- α ppli Auto Start
･
i-
α
ppli DX
･
Flash movie which uses the date and time setting
･
Software Update
Changing initial settings from the standby display
Auto time adjust
：
Set whether to automatically adjust the time and
time difference.
ON
: In Japan, automatically adjusts the time
according to the time information obtained from
the DoCoMo network. Outside Japan, when the
information to adjust the time difference is
received from the network of the connected
service provider, automatic adjustment takes
place.
OFF
: Select when setting the date and time
manually.
･
The entered number can
be increased or decreased
with
%
. You can also
highlight the number with
&
to reenter.
Offset
：
Specify the amount of time advance (+) or delay
(-) so that your terminal’s clock advances from or
delays to the obtained time.
Date
,
Time
：
Set a date between January 1, 2000 and
December 31, 2050.
Time zone
：
Select the area (time zone) to set on the FOMA
terminal. In Japan, set
GMT
+
09:00
.
Summer time
：
Set the summer time.
ON
: The terminal’s clock advances 1 hour from
the actual time.
When the automatic time/time difference correction
is set
Next
▲