Docomo FOMA D905I, Manual

Page: 256 / 513

254 1Seg
･
When a 64K data communication call is sent or
received
*1 A confirmation screen appears.
1Seg viewing may automatically resume upon
completion of a call. You may be surprised by a sudden
sound of 1Seg while you are still holding your FOMA
terminal close to your ear.
INFORMATION
●
When the above action occurs during video recording,
recording continues without interruption of image and
sound. If you perform any of the following operations,
however, a confirmation screen appears allowing you to
save and end the recording.
･
Playing a movie/i-motion file
･
Saving data to the microSD memory card
･
Starting i-
α
ppli from data broadcast
Setting channels
Channel Setting
Before viewing 1Seg, it is necessary to set channels
and register channel lists.
･
Up to 10 channel lists can be registered.
･
To each channel list, up to 62 channels can be
registered.
Registering channel lists
Two setting methods are available: one is to select an
area from the area list (
Select Area
) and the other is to
detect channels available in your current location
automatically from broadcasting signals (
Auto channel
setting
).
1
m z
1Seg
z 6
2 Select an area or perform automatic channel
setting
■ Selecting an area:
Select area
z
Highlight a
large area
z o z
Highlight a detail area
z
o
･
To check the receivable channels of the detail
area: Highlight an area in the detail area list
z
p
･
Press
o
to select the highlighted area.
■ Performing automatic channel setting:
･
Pull out the 1Seg antenna first.
･
It takes about 10 to 60 seconds to complete
the automatic channel setting.
･
Perform this setting within the terrestrial digital
TV broadcasting service area.
a Auto channel set
The automatic channel setting starts and a
confirmation screen appears upon
completion of automatic setting.
b Yes
･
No receivable TV stations may be detected
in a place with poor broadcasting signals. In
this case,
select
an area or move to another
place and try again.
･
If multiple broadcasting areas are available,
channel numbers (remote control numbers)
may overlap between areas. When a
message appears, press
o
and select an
area preferred.
3
Enter a channel list name (up to 20 one-byte or
10 two-byte characters)
z p
■
Viewing 1Seg immediately:
p
on the
channel lists screen
z
Highlight a channel
z o
INFORMATION
●
When you select an area, channels may not be set
properly depending on the area. In this case, use the
automatic channel setting.
Using multiple channel lists
If you view 1Seg in multiple broadcasting areas,
register multiple channel lists. You can see the
channels of each area by selecting the corresponding
channel list.
1
m z
1Seg
z 6
The registered channel lists are displayed.
2
Highlight
[Not recorded]
z t
or
a
･
Follow Steps 2 and 3 (the procedures after
selecting an area or auto-channel setting) in
“Registering channel lists”.
☛
P254
3
Yes
or
No
1
m z
1Seg
z 6
2
Highlight a channel list
z o
■ Checking the channels of the channel list:
Highlight a channel list
z p
The channels registered to the list are
displayed.
Adding channel lists
Selecting the channel list to use
Upper: Remote control No.
Lower: Dial key used for
channel selection on
the 1Seg viewing
screen