Docomo FOMA D902i, Manual, Page: 409 / 500

407
Data Com
m
u
n
icat
ion
･
USB Mode Setting is switched automatically to
communication mode in about 90 seconds after the
last access to the miniSD memory card without
connecting FOMA terminal to a PC.
･
Communication such as phone call or i-mode can
not be used.
･
The call indicator flashes.
･
Click on the task tray and click
USB 大容量記
憶装置デバイス−ドライブ (E:) を安全に取り外し
ます
(Release safely the USB large memory
device-Drive E: *
1
) to quit operation of the miniSD
memory card.
*1 The character to be assigned to a drive varies
by the system of PC.
● The miniSD memory card folder structure during
operation from a PC.
☛
P340
Connecting using the FOMA USB cable
Connect by using the FOMA USB cable (optional).
a
Open the cap on the FOMA terminal’s
external connection terminal
b
Insert one end of the FOMA USB cable into
the FOMA terminal’s external connection
terminal until it clicks
c
Insert the other end of the FOMA USB cable into
the PC USB connector
･
When a PC and FOMA terminal are connected in
the communication mode,
appears on the
display of FOMA terminal.
･
If you connect FOMA terminal to a PC in the
communication mode before installing the
communication configuration file, Windows may
automatically detect that a FOMA USB cable has
been inserted, request to install a driver, and the
wizard screen will be displayed. In that case,
remove FOMA terminal and click
キャンセル
(Cancel) to exit the wizard.
■ Removing FOMA USB cable
Press release buttons on both sides of the
connector for FOMA terminal and pull it out. Pull
the connector for PC out from the side of PC.
■ Connecting while charging
FOMA terminal can be connected using a data
communication adapter D01 (optional) during the
charging. However, charging time becomes
longer.
INFORMATION
● Do not remove the USB cable during data
communication. It may cause the misoperations,
failure of PC or FOMA terminal, or loss of data.
Installation of the communication
configuration file (driver)
Install the communication configuration file on a
PC before connecting FOMA terminal to a PC to
perform communication in the communication
mode.
･
When FOMA terminal is connected with PC in the
miniSD mode, installation of the communication
configuration file is not required.
Installing the communication configuration file
Before operation, read “Before installation/
uninstallation”
☛
P406
For Windows XP
1
Insert the attached CD-ROM into a PC
･
Make sure to connect FOMA terminal to a PC
after performing Steps 1 to 3.
2 Click スタート (Start) and ファイル名を
指定して実行
(Run)
z
Enter “<CD-ROM
drive letter>: ￥ USBDRIVE ￥ D902iin.exe” in
名前 (Name)
z
Click
OK
3 Click
はい
(Yes)
A screen requesting to connect FOMA D902i to a
PC is displayed.
4 Connect FOMA terminal to a PC
A progress screen for installation is displayed
and automatically completed.
･
Connect FOMA terminal while the power is on.
･
Check type and name of the device installed.
Connector
(label facing up)
Release
button
USB connector
Example
Next
In
st
al
lation
of the com
m
uni
ca
ti
on
confi
guration
file
(d
river)