39
Bef
o
re Using
D702
iF
INFORMATION
●
The FOMA terminal display uses an active LCD. Due to the characteristics of active LCD, residual images or crossbar
may remain for a while when the battery pack is attached or removed. This is not a fault of FOMA terminal.
Charging the battery of FOMA terminal
When the battery level is low, charge the battery.
・
The battery level icon shows how much charge remains in the battery.
・
Continuous call time is an estimate of call time for FOMA terminal when it can send or receive signals
normally.
・
Continuous standby time is an estimate of operation time of FOMA terminal when it is closed and able
to receive signals normally. The call time and standby time may be reduced to about half, depending
on the amount of charge in the battery, the function settings, the ambient temperature and signal
conditions (radio waves do not or hardly reach). Using i-mode communication reduces the call
(communication) time and standby time. Even if you do not make a call or use i-mode, the call
(communication) time and standby time will be reduced by composing i-mode Mail, or starting the
i-
α
ppli software downloaded from sites or on the i-
α
ppli standby display.
・
Continuous standby time (while standing still) is the average operation time of FOMA terminal when it
is standing still, closed and able to receive signals normally.
b
With the surface with the DoCoMo logo and the
recycle mark facing up, insert the battery pack
into FOMA terminal at the angle as shown in the
figure.
Do not force the battery pack into FOMA terminal.
Doing so could damage the body connector or battery
pack terminals.
c
Push the battery pack in.
d
Place the rear cover plate so that it can slide
about 2 mm on FOMA terminal.
e
Slide the rear cover in the direction of the arrow
pushing its center with your thumb so that FOMA
terminal and the rear cover do not gap.
Failure to follow the correct procedure could damage the
rear cover.
Removing the battery pack
a
Remove the rear cover.
b
Lift the projection part of the battery pack and
remove it.
Charging time and operation time on full charge (estimates)
Charging time
Continuous call time
Continuous standby time
Approx.
140 minutes
During a voice call: Approx. 150 minutes
During a videophone call: Approx. 90 minutes
While standing still: Approx. 460 hours
While moving: Approx. 330 hours
Next
Chargi
ng t
h
e
bat
tery
o
f FO
MA
termi
nal
Summary of Contents for FOMA D702iF
