Docomo F-05A, Instruction Manual, Page: 40 / 405

38
Before Using the Handset
c
Holding the battery pack with its label surface facing
upward, align the battery pack convex part with the
concave part of the FOMA terminal and push it in the
direction of
a
and then push it in the direction of
b
until it is placed in position.
d
Align the hook of the back cover plate with concave (A),
insert it in the direction of
a
, align the tab with
concave (B), push in the direction of
b
and insert until
it clicks.
e
Set the back cover plate set screw to
a
, insert the
attached back cover plate holding tool and set the
screw.
･
Do not tighten the screw with an excessive force.
f
Align 8 tabs of the back cover with concaves of the
FOMA terminal and, while pressing the back cover in
the direction of
a
so that there is no gap between the
FOMA terminal and back cover, slide the back cover in
the direction of
b
to install it.
g
Lock the back cover by sliding its lever in the direction
of the arrow.
■ Removing
a
Perform steps
a
-
b
for attaching.
b
Holding the tab of the battery pack, lift and remove the
battery pack in the direction of the arrow.
✔
INFORMATION
･
Forcing the battery pack into FOMA terminal may damage
the FOMA terminal jack.
･
FOMA terminal or back cover may be damaged if you
attach or remove the battery pack by a method except the
procedures above or if you press too hard.
･
To prevent water from entering inside, securely attach the
back cover and lock it with the lever.
･
Rubber gasket on the back cover plate has an important
role for maintaining the waterproof performance. Do not
remove or damage the gasket. Do not let it become spotted.
Convex part
Concave part
Battery Pack
Gap (A)
Gap (B)
Hook
Tab
Tab
Back cover
Lever
Tab