DNP Imagingcomm America Corporation
13
3
Installation
Preparing the Camera
1.
Remove the camera from the shipping box. Be sure to remove any packaging material from the camera.
2.
The camera batteries must be charged prior to use. Use the supplied battery charger and allow at least 2 hours to fully
charge the batteries before proceeding.
3.
Make sure your camera LCD screen is clean.
4.
Locate the photo template stickers and select the template that aligns properly with your camera LCD screen.
5.
Carefully apply the photo template sticker that fits best to the camera. Working from the center of the sticker, slowly
press outwards to remove any wrinkles or bubbles. Go slowly to minimize air bubbles.
Figure 1. Applying the photo template sticker to the LCD screen.
6.
Connect the camera strap and the lens lanyard to the camera.
7.
Set the camera aside while the batteries charge so that you can set up the rest of your IDW500 system.
Setting up the Printer
1.
Remove your new printer from the shipping box. Open the box and remove any packaging material from the outside
of the printer.
2.
Place the printer on the work surface. Make sure that the printer is not tilted or unsteady.
3.
Plug the power cord into the back of the printer. Do not plug the power cord into the wall until later.
