10
DNP Imagingcomm America Corporation
Important Safety Instructions
IDW500 User Guide
Important Safety Instructions
Safety is paramount when installing and operating the system. These safety instructions are to protect you and the
customer and the overall public. The following bullet points apply to the safety instructions in this manual:
Read all of these instructions before setting up, installing, and operating your system.
Follow all warnings, safety precautions, and notices for all procedures in this manual.
When in doubt, stop what you are doing and reassess the safety of the situation or procedure. Never continue with a
step or procedure when there is the slightest doubt regarding safety.
Save these instructions for future reference.
General Safety Precautions
Never install or setup the system near water.
Never place the system on an unstable platform.
Never place the system near a heat source, such as a heater or furnace.
Never perform any of these steps while wearing jewelry (rings, loose necklaces, bracelets, etc.), neckties, or other
clothing that could get caught in the equipment. These items can get caught in the equipment or may conduct
electricity and cause injury.
Never insert any foreign object into the system unit without powering the system OFF first.
Never block ventilation ports; allow plenty of room around the system for ventilation.
Never use water or liquid to extinguish a fire on the system unit.
Always protect the power cord from accidental kinks, cuts, and foot traffic.
Always operate this system from the correct type of grounded power source.
Always clean and maintain the system in the prescribed manner as instructed in this manual.
Always use this equipment in the specified manner as recommended by the manufacturer.
Failure to observe safety precautions voids your warranty and may cause damage to the unit and could result in
personal injury or death.
Contact DNP Imagingcomm America Corporation immediately if:
The system is damaged due to fire or flood; or is otherwise unsafe to operate.
Any part of the system is dropped, cracked, or is not operating properly after performing cleaning and maintenance.
You have any questions not answered in this manual.
Contact Us
Need help? Contact DNP Imagingcomm America Corporation technical support at:
United States Phone
: 1.855.367.7604
Website
: www.dnpphoto.com
For hours of operation, see our website.
