DMT LS-190, Manual, Page: 11 / 76

10
Ordercode: 101600
LS-190 LED Screen Processor
Backside
Fig. 03
09) 3G-SDI Input
10) DIP switches
If the two DIP switches are in the up position, the device is operating in normal mode. If they are in
the down position, the device is in upgrade mode. While in upgrade mode, the display is off. Some
of the button lights turn on, and the device will not function. This mode should only be used by the
manufacturer, for upgrading.
Normal mode
Operation for the second controller
Operation for the third controller
Upgrade mode
11) 10/100M UDP Interface
This interface can be used for software control.
12, 15, 22, 23) U and D ports (Default port, always use U-port, but for large setups use D-port)
Output ports to a LED screen. Connect the LED screen to one of these ports using a standard CAT5 or
CAT6 cable with or without the Ethercon connector.
13) USB Interface
Control the LS-190 with its software.
14) RS232 Interface
Use this interface for maintenance and upgrading.
16) Audio Inputs
17, 24) Audio Input of the Sending Card.
18, 25) USB Control Port of Sending Card
Connect the device to a PC. The sending card is controlled by LED Studio Software or the LS-190
software controls.