DMT Controller Pixelstrip MKII, Manual

Page: 16 / 28

Ordercode: 42273
Controller Pixelstrip MKII
4. Strip length/quantity settings
With this menu, you can set the strip length. This, in turn, will determine the number of PixelStrips which you
are allowed to connect per output.
01) Press the UP/DOWN buttons until the display shows .
02) Press the ENTER button to open the menu.
03) Press the UP/DOWN buttons to toggle between the following 4 options:
1 meter. You can connect 4 PixelStrips to output # 1.
2 meters. You can connect 8 PixelStrips to outputs # 1 and 2 (4 per output).
3 meters. You can connect 12 PixelStrips to outputs # 1, 2 and 3 (4 per output).
4 meters. You can connect 16 PixelStrips to outputs # 1, 2, 3 and 4 (4 per output).
04) Press the ENTER button to confirm your choice.
Please note that the maximum cable length per output is 20 meters. Take this fact into
consideration while cabling your setup.
5. Network Settings
With this menu, you can adjust the device’s properties, such as the IP address, subnet mask and the
universes.
01) Press the UP/DOWN buttons until the display shows .
02) Press the ENTER button to open the menu.
03) Press the UP/DOWN buttons to toggle between the following 3 options:
IP address
Subnet mask
Universe
04) Once you have chosen one of the options listed above, press the ENTER button to proceed to
edition mode.
05) Press the UP/DOWN buttons to choose the piece of the IP address/Subnet mask/Universe which
needs to be adjusted and which is indicated by the [ bracket.
06) Press the ENTER button to confirm your choice.
07) Press the UP/DOWN buttons to adjust the desired seting.
08) Press the ENTER button to save changes.
6. Master/Slave Mode
With this menu, you can set the device as a slave.
01) Press the UP/DOWN buttons until the display shows .
02) Press the ENTER button to open the menu.
03) Press the UP/DOWN buttons to choose between “Yes” or “No”.
04) Press the ENTER button to confirm your choice.
15