PPC-090T User’s Manual
IUMPPC090T-01 Ver.1.4A Apr, 2016
10
1.5 Panel Mounting Instruction
1. Cut a mounting hole in the panel. (Refer to
PPC
‐
090T Dimensions
on page 11~12.) (Note 1)
2. Check and remove the twelve M3 screws in a diagonal pattern as
image below if necessary.
3. Place PPC
‐
090T face
‐
down on a clean, flat surface.
4. Slide the panel cutout around the back of PPC
‐
090T, until the panel
rests directly on the gasket. Make sure the screw holes align with
the screw holes on PPC
‐
090T.
5. The screw size is M3*L (L=wall thi 6.0mm) (Note 2)
6. Insert all twelve M3 screws into the screw holes. (Note 2)
7. Finger-tighten the M3 screws. Finish tightening the M3 screws in a
diagonal pattern using an M3 screw driver (see the image as below);
maximum torque 1.18Nm (12 kgf
‐
cm).
