D L S M A R I N E R A N G E S P E A K E R S
Thank you for buying a DLS MX26 MARINE speaker.
This manual will show you how to do a correct instal-
lation. Please read the entire manual before you begin
the installation.
Features and benefits:
- Excellent audio performance, transparent
and clear sound
- Easy installation
Installation
Install the speakers in a solid and stable panel to get the best
sound quality. Use the template to cut and drill. Fasten with
stainless steel screws. Make sure to connect with the same pola-
rity on both speakers.
NOTE! Avoid an installation close to any magnetic compass, the
speaker magnets can influence the compass needle.
The
MX26
is not water resistant but creates an excellent sound
in most installations. It is designed for use indoors in yachts and
other covered vessels.
Break-in period
Allow the speakers to play at normal volume for at least 15-20
hours. After this time the performance is correct.
Technical Assistance
For technical assistance ask the shop where the product was sold
or the distributor in your country. You can also send an e-mail to
Information can also be found on our web-site www.dls.se
We follow a policy of continuous advancement in development.
For this reason all or part of specifications & designs may be
changed without prior notice.
Warranty service
This speaker is covered by warranty, depending on the condi-
tions in the country where it is sold. If the speaker is returned for
service, please include the original dated receipt (or a copy) with
the product.
WARNING
While these speakers are made for marine applications, they are
not fully waterproof which must be taken in consideration when
doing the installation.
DLS MARINE RANGE SPEAKERS
OWNERS MANUAL
DLS Svenska AB 2009-02-17
MX26
Safety Considerations:
Your speakers must be installed in a manner which does
not interfere with your vessel’s factory installed electronic
devices. You should also take the time to securely mount
them so that they does not come loose in the event of a
collision or a sudden jolt to the vessel.
- Check before drilling any holes in your vessel to make
sure that you will not be drilling through the hull, a fuel tank,
fuel line, wiring harness or other vital vessel system.
- Protect all wiring from sharp edges (metal, fibreglass,
etc.) by carefully routing them, tying them down and using
grommets and loom where appropriate.
Filter installation and connection of MX26
Speaker connection and tweeter level select:
Use the red, blue and black cables to connect between the
filter box and speaker terminal. Note the speaker terminal co-
lour marking.
Tweeter level select:
Select tweeter level by moving the jumper inside the filter box in
four steps. Make your own tests for best result.
Tweeter level select
Select tweeter level in four steps by moving
the small jumper inside the filter box.
+2 dB - 0 - -2 dB - -4 dB
(+2dB gives the highest tweeter level)
Input from
stereo / amplifier
+
_
DLS Svenska AB
P.O. Box 13029
SE-40251 Göteborg, Sweden
Tel: +46 31 84 00 60
Fax: +46 31 84 40 21
E-mail: [email protected]
www.dls.se
More facts:
Size
6,5” ( 16,5 cm)
Nom. power (RMS)
100 Watts RMS
Maximum power
160 Watts
Frequency range
45 Hz-25 kHz
Sensitivity
91 dB / W / m
Magnet diameter
58 mm / 2,28”, neodymium
Outer diameter
165 mm / 6,5”
Mounting depth
63 mm / 2,48”
Mounting hole
140 mm / 5,5”
Tweeter
28 mm /1,1”, nanoplate
W
oofer(W)
Tweeter(T)
+
+
_
_
