Basic safety guidelines
8
User’s Manual V1.00
DLoG MTC 6
Do not switch on devices with damaged cables or plugs
Do not use the DLoG MTC 6 when a cable or plug is damaged. Have the damaged
parts replaced immediately!
Do not connect or disconnect any cables during storms
Data cables must never be connected or disconnected during an electrical storm.
2.6.
External devices
The use of additional wiring and other peripheral devices, which are not recommended or
sold by the manufacturer can result in fire, electrocution or personal injury.
If a power supply is used, only use the power supply recommended by the manufacturer.
Before connecting or disconnecting peripheral devices (exception: USB devices), the
DLoG MTC 6 must be disconnected from the power supply! Otherwise, this could
seriously damage both the DLoG MTC 6 and the connected devices!
Make sure that external peripheral devices with their own power supply are switched on
at the
same time
or
after
you start the DLoG MTC 6.
If this is not possible, please ensure that the DLoG MTC 6 is adequately protected from
power leakage caused by an external device.
2.7.
Repairs only through DLoG
As a rule, never carry out repairs on the device yourself.
Always contact DLoG’s technical support and send in your unit for repair if necessary.
On the back of the DLoG MTC 6 you will find the device’s type plate which has important
information about the device which you must quote for technical service. It provides
important information about the configuration and manufacture of the device in
abbreviated form.
Always provide technicians with the full model name and serial number.
