MODEL 8055 MicroPLUS
®
RF RECEIVER
Installation
Receiver Terminal Wiring
DoorKing Part Numbers
The model 8055 is a
High Security Encrypted “Rotating Code” RF Receiver
that is designed
ONLY
for use with Micro
PLUS
®
transmitters and is
typically installed in automatic garage door openers and vehicular gate operators. The encrypted “Rotating Code” programming in this receiver and
the companion Micro
PLUS
®
transmitters prevent copied transmitter codes from being used again to operate the garage door or gate. The 8055
receiver can store up to 40 Micro
PLUS
®
transmitter codes in its memory.
This receiver is
NOT
designed to be installed outdoors without being protected from the weather. An outdoor enclosure is available for the
8055-081 receiver if required (P/N 8057-110 - Metal Outdoor Box).
Install the 8055 receiver in a location so the antenna is
NOT surrounded by metal and is in free air as high as possible above the ground.
A longer Coax Antenna kit is available for the 8055-081 receiver if required (P/N 1514-073 - Includes antenna, mounting “L” bracket and 15 feet of
coax cable).
120 Glasgow Avenue
Inglewood, California 90301
U.S.A.
1 2
3
Built-In
Antenna
#1 Com
#2 Relay
#3 Radio
Power
12-24 V
olt
AC or DC
To Receiver Termnal #1 (Neg.)
To Receiver Termnal #3 (Pos.)
To Receiver Termnal #1
To Receiver Termnal #2
To Receiver Termnal #3
12-24 Volt Transformer
P/N 8069-080
P/N 8070-080
P/N 8071-080
From “Low Voltage Common”
From “Radio Open”
From “Circuit Board” Power
1 Butt
on
2 Butt
on
3 Butt
on
Use
ONLY
Micro
PLUS
®
Transmitters
Garage Door Opener:
To connect the 8055
receiver directly to a typical garage door opener,
connect terminals 1, 2 and 3 on the receiver to
terminals 1, 2 and 3 on the garage door opener.
Typical
Garage
Door
Opener
#2 Relay:
Normally Open (N.O.) relay
contacts are provided on terminals #1 and #2.
Relay is rated for 30 volts, 1 amp max.
1
2
3
To Receiver Termnal #1
To Receiver Termnal #2
To Receiver Termnal #3
Gate
Operator
Polarity Matters!
8055-080
Built-In Antenna
8055-081
Coax Antenna Kit
P/N 8055-080
1 2
3
F Connector
Coax Antenna Kit
(Included)
18” Coax Cable
#1 Com
#2 Relay
#3 Radio
Power
12-24 V
olt
AC or DC
Receiver T
erminal
Receiver T
erminal
P/N 8055-081
#1 & #3 Power:
Connect 12 - 24 Volt AC or DC
power to terminals #1 and #3.
If DC power is used (Transformer):
Terminal #1 is NEGATIVE and terminal #3 is POSITIVE.
Use minimum 18 AWG wire to power the receiver.
