H-SW3000 USER MANUAL V1
< 11 >
6
TECHNICAL INFORMATION
6.1
Maintenance
To avoid the H-SW3000 clogging, after every 40 hours of continuous operation, use a detergent composed of 35% vinegar and 65% distilled
water through the system and fog 10-15 times after finish heating-up to prevent the accumulation of particulate matter in the heating
element.
The recommended cleaning procedure is as follows.
1)
Unplug the product from power.
2)
Empty all fluid from the machine.
3)
Add cleaning solution to the tank.
4)
Connect the product to power and allow it to heat up.
5)
Run the product in a well-ventilated area until the tank is empty. Do not allow the pump to run dry.
6)
Refill with fog fluid to continue using the H-SW3000. Run the machine briefly to clear any cleaning solution from the pump and
heater.
7)
Excessive dust, fluid residue and dirt will degrade performance and cause overheating. Remove dust from air vents with air
compressor, vacuum or soft brush. The casing could be cleaned by the damp cloth.
Test-
run your DJPOWER®
H-SW3000 on a monthly basis to achieve the best performance.
6.2
Storage
6.2.1
Machine Storage
Before storing the machine, clean it as described in the cleaning procedure above; however, only follow steps 1 through 5. Do not refill the
tank with fog fluid if storing the machine. Cleaning the system prior to storage will help prevent any particles from condensing inside the
pump or heater while not in use.
6.3
Trouble
s
hooting
Errors
Symptom
Potential Cause
Remedies
No fluid
R
efer to “MENU MAP” chapter to for more
information
No fluid
Refill fluid
Fluid pump error
Contact Service
Low water
R
efer to “MENU MAP” chapter to for more
information
Low water
Refill water
Water pump error
Contact Service
Heat failure
R
efer to “MENU MAP” chapter to for more
information
Contact Service
Water Auto-refill
