28
©
2015 DJI. All Rights Reserved.
Remote Controller
Phantom 3 Advanced
User Manual
Status LED
Alarm
Remote Controller Status
— Solid Red
Chime
The remote controller is disconnected from the aircraft.
— Solid Green
Chime
The remote controller is connected to the aircraft.
Slow Blinking Red D-D-D......
Remote controller error.
/
Red and Green/ Red and
Yellow Alternate Blinks
None
HD downlink is disrupted.
RTH LED
Sound
Remote Controller Status
— Solid White
Chime
Aircraft is returning home.
Blinking White
D . . .
Sending Return-to-Home command to the aircraft.
Blinking White
DD .. .. ..
Return-to-Home procedure in progress.
The Remote Status Indicator will blink red and sound an alert, when the battery level is critically low.
Linking the Remote Controller
The remote controller is linked to your aircraft before delivery. Linking is only required when using a new
remote controller for the first time. Follow these steps to link a new remote controller:
1. Turn on the remote controller and connect to the mobile device. Launch the DJI GO app.
2. Turn on the Intelligent Flight Battery.
3. Enter “Camera” and tap on
and then tap “Linking RC” button as shown below.
RC Control Setting
RC Calibration
Stick Mode
Not Defined
C1
C2
Not Defined
Default stick mode is Mode 2, changing stick modes alters the way the aircraft is controlled.
Do not change unless familiar with your new mode.
You can customize the C1 and C2 buttons on the back
of the RC.
Linking RC
