Installation
©
2015 DJI. All Rights Reserved.
15
Installation
Installing the Air System on Your Aircraft
1. Prepare the two Air System antennas and some double-sided foam tape.
2. Insert the antennas into the ports on the side of the Air System and snap into place.
3. Use the foam tape to mount the Air System onto the reserved space of your aircraft
or other suitable flat surfaces.
Install the antennas before powering on the Air System.
For optimal transmission quality, point the antennas downwards and avoid
obstruction from other onboard equipment.
Only use official DJI antennas and ensure they are installed correctly.
When connecting the antennas, ensure the connector pin is aligned with the port
hole, and DO NOT apply excessive force to avoid damaging the pin.
Only remove the antennas from the Air System unless it is absolutely necessary.
When removing the antennas, use pliers to grip the metal connector, and DO NOT
apply force to the wire.
For larger aircrafts, use an extension cable to connect the antennas to the Air
System. The DJI Spreading Wings series come with an antenna mount which is
used to position the antennas perpendicular to the landing gear. Watch the video
tutorials on the official DJI website for more details.
Connecting the Ground System to Your Display Device
Select one of the video ports on the Ground System to output to your display device:
SDI – Connect your SDI monitor to the Ground System using an SDI cable.
HDMI – Connect your HDMI monitor to the Ground System using an HDMI cable.