2. Removing the dome
3. Camera installation
:
:
Lift the dome. When you push the latch
button, it is unlocked and you can lift the dome.
(1) Fix the camera setwith the supplied screws on ceiling or wall mount.
If you don't use supplied screws, the camera may fall off.
(2) Please refer to '4. Camera angle adjustment' regarding adjust
camera angle.
(3) Lens adjustment(Vari- focal Lens only)
①
By turning the "Tele- Wide" knob,
you can acces s a range of focal
lengths within specified limits.
②
Since then, by turning the "Near- Far"
knob, you can set the focus toward
the wanted object.
(4) Re- assemble the camera.
<Ceiling mount>
<Wall mount>
SC REW TP13.5x20 2EA
SCREW TP13.5x20 2EA
◐
PRECAUTION
◐
FE ATURES
◐
HOW TO INSTALL
1. Do not install the camera outdoors.
2. Choose an ideal location for the camera, since a camera unit must
be protected against moisture and vibration.
3. Be careful not to scratch the camera unit, especially lens or dome cover.
4. Use the camera within the temperature(- 10
~ +50 ).
5. Handle with care. Dropping it can cause serious damage to the camera.
6. Avoid any direct sun light toward the lens.
7. Use the AC adaptor 12V DC 300mA regulated.
1. This camera is incredibly flexible to install with its 3- axis camera con-
struction, which makes the camera ceiling, wall or slope mountable.
2. Compact size dome cover(85 phi)
3. RS- 485 interface(Pelco- D, Pelco- P protocol support) - Option
4. Advanced High Resolution(700 TV- Line) - Option
5. Support 4 different privacy zone
6.DWDR(Digital Wide Dynamic Range)
7. Multi function : High Light Mask, Lens Shading Compensation, Impact
Detection(Option), Motion Detection
8. Multi- language full OSD support
: Pushing the latch button.
<
>Remove the protection sheet after installing.
1. Opening the dome
Caution
PROTE CTION S HEET
LATCH BUT TON
If the product is to be put out of operation definitively,
take it to a local recycling plant for a disposal which
is not harmful to the environment.
CAMERA HOLDER
LENS COVER
DISK
ROTATION
U
D
R
L
Ø 84
Ø 110
Ø 85
BODY
DOME COVER
INNER DOME COVER
SC REW
SC REW
CABLE
DISK
BASE
BOARD CAMER A AS S'Y
C ONTR OL PCB
PUSH BUTTON
HARNESS
3- AXIS DOME CAMERA
MANUAL
4. Camera angle adjustment
:
(1) Pan adjustment
(2) Tilt adjustment
(3) Roll adjustment
: Grasp the disk of camera and then adjust
direction to the right or left(- 180 ~ 180 )
: Grasp the lens cover of camera and then
adjust direction to the up or down(6 ~ 90 )
: Grasp the camera holder and then rotate
(- 178 ~ 178 )
˚
˚
˚
˚
˚
˚
DIMENSION
ASSEMBLY
<Caution>
If you try to adjust the camera out of limited angle, it might cause
troubles and damage to camera.
DOP2012F
