11 |
P a g e
2.2.5
(Optional) Connecting the Auto-Level Sensor
Endstop Module
NOTE:
This section only applies to you if you have the auto-level upgrade.
The inductive auto-level
upgrade probe will come
pre-wired with a small
circuit board module.
Connect the auto-level
adaptor module to the
RAMPS board as shown.
Make sure you connect it
to the 5
th
and 6
th
row of
pins from the bottom of
the endstop connectors.
As shown in the second
image, the bottom four
rows are still exposed for
the X and Y endstops.
Connect the X and Y
endstops to the locations
as shown in the second
image.
Remember to connect
the RAMPS fan to one of
the three 12V headers.
Orientate the fan
connector so the positive
(red) wire is at the top.