34 |
P a g e
4.2.4
Test 4 Motors:
In the
Manual Control
tab, use the motor control buttons to move the X, Y and Z
axis. Start small by moving
Positive 1mm
on each axis. The corresponding axis
should move a short distance
away from the endstop.
•
Axis Moves Toward Endstop:
See troubleshooting on how to reverse an
axis. This is done by flipping the motor plug.
•
Wrong Axis Moves:
e.g. c1 on X axis and Y axis moved, check
motor plugs are in correct location on RAMPS board.
•
Axis Does Not Move:
See troubleshooting guide on checking an axis that
does not work.
