REV E 3/25/20
877.582.3569
35
FT7000, RACK MONITOR MANUAL 11033PA-ATEX
Bypass Procedure
If a trailer cannot satisfy the requirements of the monitor, a bypass function will allow the monitor to
become temporarily permissive.
If a terminal operator has deemed the trailer as safe, and chooses to bypass the safety checks provided
by the FT7000, the operator will hold their bypass card to the bypass indicator. Once the FT7000 has
read the bypass card, and verified it is paired, the unit will enter bypass mode.
Ground bypass cards can only enter ground bypass mode, indicated by a blue bypass light.
Overfill bypass cards can only enter overfill bypass mode, indicated by a red bypass light.
Once the FT7000 has been put into bypass mode, any of the following conditions will end the bypass:
•
A trailer sensor becomes wet
•
Rack cord is disconnected from trailer
•
Any paired bypass card is scanned again
•
30 minutes has elapsed
CAUTION: ENTERING BYPASS MODE MAY ALLOW UNSAFE CONDITIONS TO OCCUR!
ATTENTION: L’UTILISATION DU MODE « BYPASS » PEUT ENGENDRER DES SITUATIONS NON
SÉCURITAIRES.
