dIXEL
dIXEL
dIXEL
dIXEL
Operating Instructions
cod.
cod.
cod.
cod. 1592017410
1592017410
1592017410
1592017410
1592017410 XLH360 GB r1.0 15.04.2005.doc
XLH360
7/16
LED
MODE
FUNCTION
°C
FLASHING
If measurement unit is °C, it flashing on programming mode
°F
ON
°F
°F
FLASHING
If measurement unit is °F, it flashing on programming mode
ON
The compressor is running
FLASHING
- Anti-short cycle delay enabled
ON
The defrost is enabled
ON
Heating enabled
FLASHING
Temperature Set programming phase
ON
- ALARM signal
ON
Fan is running
ON
RH%
ON
Dehumidifying enabled
ON
Humidifying enabled
(umid)
FLASHING
Humidity Set programming phase
ON
Running phase is in progress
FLASHING
Dripping or stopping phase is in progress
FLASHING
Setting of the duration of the cycle
8.2
HOW TO SEE AND MODIFY THE SET POINT (TEMPERATURE AND HUMIDITY)
Or
1.
Push and immediately release the
SET
key: the display will show the Set point
valueand the correspondant set icon starts flashing;
2.
To change the Set value push the
o
o
o
o
or
n
n
n
n
arrows within 10s.
3.
To memorise the new set point value push the
SET
key again or wait 10s.
8.3
TO START A MANUAL DEFROST
1.
Push the
DEF
key for more than 2 seconds and a manual defrost will start.
8.4
TO START A EXTRACTION CYCLE MANUALLY
Hold pushed the UP key for more than 2 sec.
To stop manually the cycle:
when the cycle is running, hold pushed the UP key for more
than 2 sec.
8.5
TO ENTER IN PARAMETERS LIST “PR1”
To enter the parameter list “Pr1” (user accessible parameters) operate as follows:
+
1.
Enter the Programming mode by pressing the
SET %RH
+
n
n
n
n
for few
seconds. (°C or °F start flashing)
2.
The instrument will show the first parameter present in “Pr1”
8.6
TO ENTER IN PARAMETERS LIST “PR2”
To access parameters in “
Pr2
”:
1.
Enter the “Pr1” level.
2.
Select “Pr2” parameter and press the “
SET %RH
” key.
3.
The “PAS” flashing message is displayed, shortly followed by “0 - -” with a flashing zero.
4.
Use
o
o
o
o
or
n
n
n
n
to input the security code in the flashing digit; confirm the figure by pressing “
SET %RH
”.
The security code is “321“.
5.
If the security code is correct the access to “Pr2” is enabled by pressing “
SET %RH
” on the last digit.
Another possibility
is the following: after switching ON the instrument the user can push
SET %RH
+
n
n
n
n
keys within 30 seconds.
