v
DiViS
15
w w w .
DiViS
D V R . c o m
7. DIAGNOSTIC
Standard diagnostic will be performed automatically on every camera startup
.
1.
PAN ORIGIN TEST
Zero point of Pan is located during the Panning test.
2.
TILT ORIGIN TEST
Zero point of Tilt is located during the Tilt test.
3.
TX CONNECTION TEST
The camera checks the connection with external devices such as DVR or Controller for 60 seconds.
“Ok” message will appear if it passes the TX Connection Test.
* If "Not Tested" message is displayed, some possible causes are :
- No signal has been transmitted from the DVR or Controller.
- Wrong connection configuration such as protocol, baud rate, or RS-485 connection. Check
whether or not the camera is set up properly.
4.
CAMERA COMM TEST
Camera communication is also checked.
OK should be displayed in these four tests before installation.
If the camera passes all the above Tests, “NOW EEPROM CHECKING” and “ALL DATA INITIALIZING”
messages will appear, and the camera should be ready to operate.
CAMERA ID : 001
BAUD RATE : 2400 BPS
WAITING………
PAN ORIGIN TEST OK
TILT ORIGIN TEST OK
TX CONNECTION TEST OK
CAMERA COMM TEST OK