DITECH DT5649, Instruction Manual

Page: 32 / 44

32
ENG
DEUDEU
Commissioning
ENG
1. Disconnect from the mains network and secure against unintended
activation.
2. If necessary pull off the rocker from the frame of the respective switch.
3. Pull off the frame and the clamping/support piece from the switch.
4. Loosen the cabling and remove the existing switch if necessary.
5. Connect the wiring as follows:
Switching off Conductor to lamp/light to connection terminal 2.
(see fig. 1 page 2)
Intermediate switch circuit Corresponding supply lines to the inter-
mediate switch at connection terminals 1 and 2. (see fig. 3 page 3)
Multiway switching circuit Corresponding supply lines to the tog-
gle switch at connection terminals 1 and 2. (see fig. 4 page 4)
6. Connect the external conductor to connection terminal L.
7. Connect the neutral conductor to connection terminal N.
8. Connect the neutral conductor of the lamp to the neutral conductor
of the building installation.
9. Screw the device to the flush-type box.
The system key must be in the left upper corner for the installation.
10. Install the adapter to the rocker (see fig. 5 page 4).
11. Fix the rocker together with the adapter into the frame on the actuator
(see II in figure on the left). Both catches must fit to the oblong holes.
12. Connect to the mains network.