Thank you for ordering 2-in-1 floor and table tablet kiosk stand. Let’s start setting it up!
Parts you will find
Aluminium Plate
Bended tube
Straight tube
Turn and put on floor
Counter clockwise tightening the screw Counter clockwise tightening
using
Hex end screwdriver
the screw of another side
Step2 Straight Tube
and
Bended Tube
Connection
Acrylic Cover
Long Screw"a" 8pcs
Short Screw"b" 4pcs
Flat end Screw"c" 4pcs
Acrylic Corner
Base
Screwdriver
Insert the bended tube Remember
Counter clockwise tightening
Ready for next step
feed the cable to the bended tube the screws of both sides using
Hex end screwdriver
hexagon end 1pc Spline end 1pc
Step3
Connect the
Aluminium Plate
to
Step4
Connect 4pcs
Acrylic corners
to
the
Bended Tube
using 4pcs
Screw "b"
the
Aluminium Plate
using 4pcs
Screw"a"
using
Spline end screwdriver
Before assembling please prepare the extension cable if you want power routing
through stand. Cable not included
Corner A at A position,
Corner B at B position,
Corner C at C position,
Step1
Base
and
Straight Tube
Connection
Please remember to insert cable when install if need power routing.
Do not fully tighten all
screws!
Locate the pole as above picture
4pcs
Flat end screws"c"
to tighten
Need to adjust in next step.
The lock point face to the handle Base & Pole upside down
and insert cable
User Manual