User manual in Original
Doc. ref: 500A_GTS-E65_am_en_210608
DISPERATOR AB
Tel: 08-724 0160
E-mail: [email protected]
Mälarvägen 9, 141 71 Segeltorp
Web page: www.disperator.se
41 / 48
40 / 48
10.3. Overhaul of Protection Cover with Switch, Assembly and Connections
The below designations within brackets refers to the position numbers on the exploded view drawing
with associated spare part list of the disposer in section 10.2.
Note that the machine’s rear panel is removable for easy access to
the parts located at the back of
the cabinet during service work.
The following checks of the machine must be done in accordance with the table in section 10.7.
“Overhaul and Maintenance Intervals” – i.e. make sure that:
•
the rubber seal (P32) around the protection cover key (P33) for the interlock switch (P31) is in good
condition, and that the sealing surfaces are clean and undamaged. If necessary, replace the seal
and clean the sealing surfaces,
•
all nuts (P18) between disposer and assembly are tightend and in good condition,
•
the pump is securely fixated in the cabinet,
•
the hose and piping between the disposer and the pump are securely fixated and
•
that there are no leaks,
•
pump connection to the drain pipe is tight and fixed,
•
the flushing water connection to the machine is tight and fixed,
•
all cable glands are tight and fixed,
•
the cabinet is securely fixated either to the wall/bulkhead or the floor/floor plate.
10.4. Overhaul and Maintenance of the Pump
The Original Operation and Maintenance Instruction for the pump are delivered with this machine
(GTS-E65-Food Waste Processor). Note that the machine’s rear panel is removable for easy access to
the parts located at the back of the cabinet during service work.
Summary of Contents for 500A-GTS-E65 EXCELLENT SERIES
Page 2: ......
