Page 17
Remote Control Settings
Remote Control Settings
Change the Address
When you receive your system, your remote control and receiver have been set
to communicate on address 1. However, because UHF signals travel long
distances and go through walls, a neighbor's UHF Pro remote could control your
receiver by mistake if they are on the same address. Once all connections have
been made, to handle this problem, you can change the address on your remote
control and the receiver as follows:
1. Press
SYSTEM INFO
button on the receiver's front panel. The
System Info
screen displays and shows the
Remote Address
.
Write down the address shown: _____________
2. Press and hold the
SAT
button on your remote control for about
three seconds, until all of the mode buttons light up, and then let
go of the
SAT
button.
3. Use the
NUMBER PAD
buttons to enter any number between 1
and 16, but not the one you wrote in step 1.
Write down the number you entered:___________
4. Press the
POUND
(#)
button. If you entered the address
correctly, the
SAT
mode will flash three times.
5. Press the
RECORD
button.
Note
: Make sure the
Remote Address
you see on the
System
Info
screen is the same as the one you entered in step 3. If it isn't,
the remote cannot control the receiver.
6. Press the
SELECT/OK
button to close the
System Info
screen.
Checking the Remote Control Address
1. Press and hold the
SAT
mode button for three seconds, until all
of the mode buttons light up, and then let go of the
SAT
button.
2. Press the
POUND
(#)
button twice. The
SAT
mode button will
flash the same number of times as the address number (for
example, three flashes means address 3).
Summary of Contents for 138410
Page 107: ...Appendix Page 118 Notes...