Dish Network 104333, User Manual

Page: 4 / 32

SAT (Satellite Receiver) Mode
4 104333
U
SING THE
R
EMOTE
C
ONTROL
B
UTTONS
SAT (S
ATELLITE
R
ECEIVER
) M
ODE
SAT M
ODE
B
UTTON
The remote control already is set up to control the satellite receiver.
But, you must press the
SAT
mode button to set the remote to
SAT
mode. The SAT mode button’s back light turns ON to show that the
remote is set to
SAT
mode. Make sure to keep the remote in
SAT
mode to use the buttons as described in this section.
AUX M
ODE
B
UTTON
Set up the remote to control the television and do not setup the remote
in
AUX
mode. If you do this, then with the remote in
SAT
mode you
can press the
AUX
mode button to turn the television ON or OFF.
This allows you to turn the TV on or off without leaving SAT mode.
TV/V
IDEO
B
UTTON
If you connect the receiver using only its back panel RF or VHF
connections, use this button to switch the receiver between the satellite
signal (routed into the receiver’s
Satellite In
input) and another video
signal such as cable or broadcast TV antenna input (routed into the
receiver’s
TV Antenna Cable In input).
M
ENU
B
UTTON
Press this button to open the
Main Menu
.
Some of the features described below may not
apply to your satellite receiver. See the receiver
User Guide for details about the receiver’s features.
If a remote control button is not described in this
section, it does not work in
SAT
mode.