Fig. 22
Flush mounted to dash
4.
Tuck and secure any extra wire from moving parts and test operation
B.
Bracket Mount
(No drilling)
1.
Locate a flat surface at location of choice within 3.2 ft. of module to
mount USB support bracket (See
Fig. 23
) using adhesive/tape or
screws (included).
Fig. 23
USB mounting bracket
2.
Insert USB cable male terminal through hole in bracket (See
Fig. 23
)
and connect to installation charging port (See
Fig. 20
Fig. 24
3.
Snap USB cable head (See
Fig. 24
) to bracket until flush (See
Fig. 25
)
Fig. 25
4.
Connect red or yellow wire to 12V. To maintain ability to charge without
ignition key, connect red wire to Battery (
Always on
) power at pin 1 or
2 of factory radio 10-pin plug. To charge with ignition key, connect red
wire to Accessory power at pin 7 of factory 10-pin plug. Connect black
wire to ground (pin 6)
Factory plug
Accessory wire
Ground wire
10-pin radio plug (white)
Pin 7 (white)
Pin 6 (black)
Battery wire
Pin 1 (Brown/Green)
5.
Tuck and secure any extra wire away from moving parts and test
operation (
See Bluetooth Pairing and Connection
)
