page 22 of 48
ANDIAMO Hardware Guide - Version 1.0
CHAPTER 4: Operation
Blinking LEDs are also used to indicate an error (e.g. missing sync). Concentrate on
the section where one LED is blinking and the remaining LEDs are glowing weak.
Menu Control
The basic functions of the converter can be accessed using a simple menu to allow
for local operation. Two pairs of push buttons are used for navigation and settings.
See „CHAPTER 5: Menu Navigation“ on page 36.
SELECT
Push button
Press longer than 2 seconds to enter the menu.
Press short to cycle through the menu.
SET
Push button
Only active in menu mode. Press short to adjust a
setting.
When the menu mode is active a LED will blink in one of the sections while the
remaining LEDs of this section are glowing weak.
This indicates:
• a setting can be adjusted in this section
• the blinking LED(s) is the selected option in this section
After a short period of time the menu mode is exit automatically.
NOTE
globcon Control
Further functions of the device are accessible via globcon remote control with the
Matrix mode enabled - see "Bank Routing vs. Matrix Mode" on page 28:
• Input - level (gain & trim), mute, polarity
• Output - level, mute, polarity
• single channel routing
• EARS for MADI and audio network
• MADI redundancy switchable
