22
Directed Digital System MIT4
© 2015 Directed. All rights reserved.
Module programming
Refer to "LED diagnostics and troubleshooting" on page 23 for more information and for troubleshooting
purposes.
To connect the module:
1
Please ensure that the vehicle is in a safe location an cannot move
forward during programming. For vehicles equipped with a manual
transmission, make sure the gearshift lever is in the neutral position.
2
Connect all the harnesses to the Directed Digital System,
EXCEPT
the
white12-pin main power harness.
Connect all but the
white 12-pin harness
3
Connect the white12-pin main power harness, and wait until the LED turns
ON solid red.
Must be connected LAST
&
Solid
4
Turn the Ignition ON using the key.
START
Key OUT
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
5
The LED turns ON green for 3 seconds and shuts off.
&
Off
Solid x3 secs
6
Turn vehicle ignition OFF once the module is successfully programmed.
START
Key OUT
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
7
Pair remotes (if applicable). For information on how to pair a specific
remote, please refer to its corresponding owner documentation, which
can be found inside the product packaging of the complete system or on
www.directechs.com.*
Pair
remotes*
8
By default, the tachometer is preprogrammed for the vehicle. For
instructions on how to program tach, refer to the Analog Installation
Guide, which can be found on www.directechs.com.
Initialize
tachometer
* Your aftermarket remote may differ from the model shown in the illustrations.
