Introduction
The MA3 firmware for Directed Digital Solutions is compatible with specific Mazda, Scion and Toyota vehicles.
It is a complete solution for remote start, security (if applicable), bypass interface, and convenience. This guide
provides information on the installation of the module using MA3. If you would prefer using this system as a
digital solution, go to www.directechs.com and search for the make, model and year of the vehicle. This will
allow you to find the proper firmware and corresponding installation guide.
Warning!
This module can only be programmed via the web tool, which can be found on www.directechs.com or using the
Directechs Mobile application for mobile devices. Features and functions will become accessible when you connect the module
using the XKLoader.
Pre-installation and application warnings
Firmware notes:
This section highlights important information for this specific firmware and will assist in
pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
THMAC1
Keys required for
programming
1
Keys required for
operation
see note
5
Important!
In these vehicles, the factory keyless entry module is sensitive to interference and may cease to operate without
notice. Please ensure you disconnect the (-) terminal of the battery prior to disconnecting and reconnecting the connectors at
the start-stop module below the steering wheel to avoid damage to the keyless entry module.
The optional Plug & Play
THMAC1
T-Harness is sold separately.
Scion iA and Toyota Yaris Sedan are not compatible with T-Harness
THMAC1
The OBDII Diagnostic Connector features will remain the same even when the T-Harness is installed.
All connectors are displayed from the wire side (unless specified otherwise).
Refer to the "Vehicle wiring reference chart" following each installation type.
No takeover feature is available. The vehicle will shut down as soon as a door is opened.
To remote start the engine, the hood, hatch, and all doors must be closed.
When installing this solution with T-Harness
THMAC1
in one of the vehicles from this guide, the vehicle's OEM alarm will
no longer be functional. The installation of a hybrid system (remote starter and alarm combo) is highly recommended to
preserve vehicle security.
It is normal for the key symbol to flash during remote start runtime.
Parking lights for Mazda 3 can also be found in drivers kick. Please refer to www.directechs.com for additional information.
General notes:
This section highlights important information for this specific firmware.
[1]
The installation of an aftermarket hood pin is
ONLY
required on vehicles that are
NOT
equipped with a factory hood pin.
[2]
The siren is
ONLY
required when enabling the security features during module flashing.
[3]
Only required to retain OEM remote functionality during remote start runtime if not using the
THMAC1
T-Harness.
[4]
See page 22 for more information about accessing the parking wiring. Parking lights for Mazda 3 can also be found in
drivers kick. Please refer to www.directechs.com for additional information.
[5]
Type 5 vehicles only are not compatible with
THMAC1
THarness. 1 (one) key is required for operation. For key wrap
instructions, refer to page 22.
[6]
Connection required when enabling the security features during module flashing.
[7]
Connection required when using a T-Harness
THMAC1
.
Additional parts required (maximum required):
Diode 6A
0 x 1A Diodes
86
85
30
87a
87
2 x Relay
Resistor 100
Ω
0 x Resistor
Fuse 7.5A
1 x Fuse
4
Directed Digital Solutions MA3
© 2018-03-06 Directed. All rights reserved.
