Introduction
The FORD12 firmware for DS4+ is compatible with specific Ford and Lincoln vehicles. It is a complete solution
for remote start, security (when security features are enabled), bypass, and features built in Bluetooth 4.0
allowing you to configure and control your system. This guide provides information on the installation of the
module using FORD12. Please refer to the DirectLink application or www.directechs.com for more information
about which configuration is best for your application.
Warning!
This module is designed to be configured using the DirectLink application for mobile devices, however it can also
be configured using the web tool located at www.directechs.com. To download the DirectLink mobile application, please visit the
Google Play or Apple store.
Pre-installation and application warnings
Firmware notes:
This section highlights important information for this specific firmware and will assist in
pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
THFON2
Keys required for
programming
1
Keys required for
operation
0
Compatible with FORD12 v1.29+.
It is It is important to note this installation enables the OEM remote starter and the remote start system will not work in the
following conditions:
The ignition is on.
The alarm system is triggered.
The hood is open.
The transmission is not in Park (P).
The vehicle battery voltage is too low.
The service engine light is on.
The following remote start features can be configured via the information display:
Climate control.
Heated seats/steering wheel.
Runtime.
Remote start enable/disable.
For best results, program the remote starter runtime to match the OEM setting.
The vehicle pit stop/idle mode feature is
NOT
available in this firmware.
This product is
NOT
compatible with vehicles equipped with a manual transmission.
The optional Plug & Play
THFON2
T-Harness is sold separately.
The OBDII Diagnostic Connector features will remain the same even when the T-Harness is installed.
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic
connector.
It is important to check that the fuses are positioned correctly in the module. Proper fuse positioning is displayed on each
wiring diagram.
Refer to the "Vehicle wiring reference chart" following each installation type.
General notes:
This section highlights important information for this specific firmware.
[1]
The installation of an aftermarket hood pin is
ONLY
required on vehicles that are
NOT
equipped with a factory hood pin.
[2]
The siren is
ONLY
required when enabling the security features during module flashing.
4
DS4+ FORD12
© 2017-10-12 Directed. All rights reserved.
