Module programming
Refer to "LED diagnostics and troubleshooting" on page 23 for more information and for troubleshooting purposes.
Key type vehicles
To connect the module:
1
Please
ensure
that the vehicle is in a safe location and cannot move forward during
programming. For vehicles equipped with a manual transmission, make sure the gearshift
lever is in the neutral position.
2
Connect
all the harnesses to the DS4+,
EXCEPT
the 12-pin main power harness.
Connect all but the
12-pin harness
3
Connect
the 12-pin main power harness, and wait until the LED turns ON solid red.
Note:
To skip the transponder programming and use convenience features only, press the
programming button 5 times. Wait unil the LED turns ON solid orange before proceeding.
Must be
connected LAST
&
Solid
4
Turn
the ignition ON. The LED will flash green then remain ON solid green
for 3 seconds, then will turn OFF.
Note:
When skipping transponder programming, the LED flashes orange,
then turns ON solid orange for 3 seconds, before turning OFF.
START
Key OUT
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
&
&
Solid green
x 3 secs
Flashes
green
Off
5
Turn
the vehicle ignition OFF.
START
Key OUT
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
6
Pair
remotes (if applicable). For information on how to pair a specific remote, please
refer to its corresponding owner documentation, which can be found inside the product
packaging of the complete system or on www.directechs.com.*
Pair
remotes*
7
By default, the tachometer is preprogrammed for the vehicle. For instructions on how to
program tach, see page 26.
Initialize
tachometer
* Your aftermarket remote may differ from the model shown in the illustrations.
Smart key vehicles
To connect the module:
1
Please
ensure
that the vehicle is in a safe location and cannot move forward during
programming. For vehicles equipped with a manual transmission, make sure the gearshift
lever is in the neutral position.
2
Connect
all the harnesses to the DS4+,
EXCEPT
the 12-pin main power harness.
Connect all but the
12-pin harness
3
Connect
the 12-pin main power harness, and wait until the LED turns ON solid red.
Note:
To skip the transponder programming and use convenience features only, press the
programming button 5 times. Wait unil the LED turns ON solid orange before proceeding.
Must be
connected LAST
&
Solid
4
Turn
the ignition ON. The LED will flash green then remain ON solid green
for 3 seconds, then will turn OFF.
Note:
When skipping transponder programming, the LED flashes orange,
then turns ON solid orange for 3 seconds, before turning OFF.
&
&
Solid green
x 3 secs
Flashes
green
Off
21
DS4+ FORD12
© 2017-10-12 Directed. All rights reserved.
