Module programming
Refer to "LED diagnostics and troubleshooting" on page 13 for more information and for troubleshooting purposes.
To connect the module:
1
Please
ensure
that the vehicle is in a safe location and cannot move forward during
programming. For vehicles equipped with a manual transmission, make sure the gearshift
lever is in the neutral position.
2
Connect
all the harnesses to the Directed Digital Solutions,
EXCEPT
the 12-pin main power
harness.
Connect all but the
12-pin harness
3
Connect
the 12-pin main power harness, and wait until the LED turns ON solid red.
Note:
To skip the transponder programming and use convenience features only, press
the programming button 5 times. When the LED turns ON solid orange, proceed to
step 4.
Must be connected LAST
&
Solid
4
Insert
and
turn
the key to the Ignition position. The LED flashes orange, then solid green for
3 seconds.
Note:
If the transponder programming was skipped, the LED turns ON solid orange for
3 seconds, then turns OFF when programming is completed.
Flashes
ON
ST
AR
T
Key IN
IGN
OFF
Solid
x 3 Secs
5
Turn
the key to OFF and
remove
it from the ignition barrel, once the module is
successfully programmed.
START
Key OUT
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
6
Pair
remotes (if applicable). For information on how to pair a specific remote, please
refer to its corresponding owner documentation, which can be found inside the product
packaging of the complete system or on www.directechs.com.*
Pair
remotes*
7
DATA Tach: Firmware using DATA Tach, the tachometer is preprogrammed for the vehicle
and no further action is required. For instructions on how to adjust tach or use Virtual tach,
see page 16 (not needed with hardwired or data tach applications).
Hardwired Tach: Firmware using the Violet/White Hardwire Tach input will require
programming. For instructions on how to program or adjust tach or use Virtual tach, see
page 16 (not needed with hardwired or data tach applications).
Initialize
tachometer
* Your aftermarket remote may differ from the model shown in the illustrations.
You have successfully completed the module programming sequence.
12
Directed Digital Solutions HK14
© 2019-11-15 Directed. All rights reserved.