17
933.FORD6 3.24.195.3 2010 Lincoln MKS
©2022 VOXX•DEI LLC. All rights reserved.
Module programming for security-only installations
Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.
To connect the module:
1
Please
ensure
that the vehicle is in a safe location and cannot move forward during
programming. For vehicles equipped with a manual transmission, make sure the gearshift
lever is in the neutral position.
2
DS3+: Connect
the 12-pin main power harness to the DS3+ module
FIRST
.
Wait
until the LED turns ON solid orange before proceeding to the next step.
Solid
Must connect
12-pin FIRST
4
2
4
4
2
22
8
10
12
DS3/DS3+
DS4+: Connect
the 12-pin main power harness to the DS4+ module
FIRST
.
The LED will turn ON solid blue for 1 second to confirm Bluetooth communication.
Wait
until the LED turns ON solid orange before proceeding to the next step.
Solid
Solid
x1 Sec
Must connect
12-pin FIRST
4
2
4
4
2
22
8
10
12
DS4/DS4+
3
Connect
the remaining harnesses to the module.
Connect
remaining
harnesses
4
Insert
and
turn
the key to the ON position, and
wait
until the LED turns OFF.
START
Key OUT
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
&
Off
5
Turn
the key to the OFF position, and
remove
it from the ignition barrel.
START
Key OUT
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
6
Pair
remotes (if applicable). For information on how to pair a specific remote, please
refer to its corresponding owner documentation, which can be found inside the product
packaging of the complete system or on www.directechs.com.*
Pair
remotes*
* Your aftermarket remote may differ from the model shown in the illustrations.
You have successfully completed the module programming sequence.
