13
933.FORD6 3.24.195.3 2010 Lincoln MKS
©2022 VOXX•DEI LLC. All rights reserved.
Module programming
2 Keys required!
For
Security-Only
and
Convenience-Only
programming, see next sections.
1
Ensure vehicle is in a safe location, and cannot move forward during programming. For
vehicles equipped with a manual transmission, make sure the gearshift lever is in the neutral
position.
2
DS3+: Connect the 12-pin main power harness to the module FIRST.
Wait until the LED turns ON solid red before proceeding to the next step.
DS4+: Connect the 12-pin main power harness to the module FIRST.
The LED will turn ON solid blue for 1 second to confirm Bluetooth communication.
Wait until the LED turns ON solid red before proceeding to the next step.
3
Connect the remaining harnesses to the module.
4
Insert the
first key
and turn the key to the ON position.
a.
Wait 5 seconds, then remove the key.
The LED may stay solid red, or flash red, green or orange.
Important! Proceed with the next step within 5 seconds.
b.
5
Insert the
second key
and turn the key to the ON position.
a.
Wait 5 seconds, then turn the key OFF.
The LED may stay solid red, or flash red, green or orange.
Important! Proceed with the next step within 5 seconds.
b.
6
Turn the second key back to the ON position.
The LED will turn on solid green for 3 seconds, then shut off.
Note: If the LED stays solid red, check your connections are try again.
7
Turn the key off when the module is successfully programmed.
8
Pair remotes (if applicable).
For information on how to pair a specific remote, please refer to its corresponding owner
documentation, which can be found inside the product packaging of the complete system or
on www.directechs.com.*
9
DATA/Hardwired Tach Learning: When using Data Tach, it is recommended to follow the Tach
Learning procedure. However, when using a Hardwired Tach, the procedure is mandatory.
For more information, refer to the Tach Learning procedure section.
* Your aftermarket remote may differ from the model shown in the illustrations.
