5
403.TL10 2.29 2017 Toyota Camry (H Key)
©2022 VOXX•DEI LLC. All rights reserved.
Pre-installation and application warnings
Firmware notes:
This section highlights important information for this specific firmware and will assist in
pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
Keys required for
programming
1
Keys required for
operation
0
It is important to make sure you
DO NOT
connect the keysense wire in the installation for each of these vehicles or you will
encounter issues when attempting to start the vehicle.
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic
connector.
Refer to "Vehicle connections" following the wiring diagram.
General notes:
This section highlights important information for this specific firmware.
[1]
Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D. Also
please note that by default, the tach is set to 1000 rpm on hybrid vehicles.
[2]
Autolight Interrupt connection required
ONLY
if the vehicule is equipped with automatic headlights.
[3]
Parking lights, trunk release, lock and unlock connections required when not available through Data.
[4]
Depending on the vehicle's trim, the TPMS Ignition Interrupt connection may be required to obtain OEM remote functionality
during runtime.
Note
: the TPMS light may flash during runtime.
Key type
Some Toyota 2010+ models have different encryption types. Please look at your key blade and identify the markings.
G-stamped keys
Standard Key
H-stamped keys
H
For vehicles with H-stamped keys, see
the TL10 firmware.
For vehicles with G-stamped keys, see
the TL5 & TL7 firmware.
For vehicles with dot-stamped keys,
see the TL11 firmware.
Note:
Some replacement keys
may not have any markings on
the key.