13
403.GM9 2.42 2013 Cadillac SRX (Smart Key)
©2022 VOXX•DEI LLC. All rights reserved.
Module programming
1
Wait until the LED turns ON solid red.
Note: To skip the transponder programming and use convenience features only, press the
programming button 5 times. When the LED turns ON solid orange, proceed to step 4.
2
Remove battery from one key fob, and make sure that the other key fob is located more than
10 feet away from vehicle.
3
Put the key fob (with battery removed) in the keyport. (Refer to Keyport location).
4
Press and hold the Push-to-Start (PTS) button until the ignition turns ON, then release. The
LED flashes orange then green.
Note: If the LED starts flashing 2x red, press and hold the Push-to-Start (PTS) button with the
brake pedal applied. When the engine begins cranking, let go of the button. The LED flashes
orange then green, proceed to step 5.
Note: If the transponder programming was skipped, the LED turns ON solid orange for 3
seconds then shuts OFF when programming is done.
5
Press the PTS button once to turn the ignition OFF. The LED will flash orange slowly.
6
Remove the module from the vehicle and reconnect it to your computer. The web site will
automatically recognize that you are moving onto the second phase of the programming
sequence.
7
Click on Submit Key2GO Request.
8
Once the configuration is completed, reconnect the module. The LED turns ON solid green for
3 seconds, then turns OFF.
You have successfully completed the module programming sequence.
