Directed Digital Solutions NISS06
© 2019-12-30 Directed. All rights reserved.
Quick Reference Guide
Pit stop/idle mode
1
Stop
the vehicle in a safe parking spot and
put
the
gear in Park (P).
Put
gear in
Park
2
Press
the Remote Start button on the transmitter.*
The parking lights will flash once to indicate the
vehicle is now in Pit Stop Mode.
Parking lights flash x1
14:36
Press Remote
Start button*
&
3
It is safe to
leave
the engine running and
exit
the
vehicle with the factory remote in hand.
Note
: We recommend that you always
lock
the
doors of your vehicle when leaving it unattended.
14:36
Exit vehicle
with remote
* Icon and remote appearance may differ depending on the model purchased.
List of available commands
Note that the information below is for many Viper, Clifford, Python, Autostart and
AstroStart models. Icons and commands may differ depending on the model and
options purchased. Refer to your authorized installation center for more specific
information.
Button(s)
Actions
Press
&
hold
for 1 second to lock.
Press
&
hold
for 1 second to unlock.
*
Press
&
hold
for 1 second to remote start.
*
Press
&
hold
for 5 seconds to activate the trunk release (optional).
* Icon and remote appearance may differ depending on the model purchased.
Sending commands to your vehicle
Whether you want to remote start the engine, lock/unlock the doors or pop the trunk,
there are 3 possible ways you can send commands to your vehicle, using the:
• Factory remote.
• Aftermarket remote.
• Directed SmartStart application via your smartphone.
If applicable, you can also start the engine remotely by pressing the Lock button 3
times quickly on your factory remote.
Vehicle takeover with Get In and Go
1
Close
the vehicle doors, hood and trunk, then
press
the Remote Start button on the transmitter to start the
vehicle.*
14:36
Press Remote
Start button*
2
Press
the Unlock button on the factory or aftermarket
remote.*
14:36
Press Unlock on
either remote*
Complete the following steps within 45 seconds or the vehicle will shut down.
3
Enter
the vehicle, while making sure the factory
remote is inside with you.
14:36
Enter vehicle
with remote
4
Depress
the brake pedal for a minimum of 3 seconds,
put
the car in gear and
drive
off.
Ready to
drive off
* Icon and remote appearance may differ depending on the model purchased.
Get In and Go
Get In and Go is designed to provide users with easy takeover when entering their
Push-to-Start (PTS) equipped vehicle, once it has been remote started.
Typically, users would have to remote start their vehicle, then get inside and press
the PTS button to perform a takeover. There is therefore a physical action required
to drive away. With Get In and Go, you simply remote start the vehicle, unlock the
doors, get in and go... All that's left to do is put the gear in drive and drive off.