Dionex UltiMate 3000 Series, Operating Instructions Manual, Page: 49 / 236

UltiMate 3000 Series:
SD, RS, and BM Pumps
Operating Instructions Page 35
3.5.3 Configuring the Pump
3.5.3.1 Initial Installation
On each configuration page for the pump, check and change the settings if necessary and
select additional settings if needed. You may reopen the configuration pages later again to
change the settings (

page 42).
Tip: Changing the settings for a specific application in the Commands dialog box,
in a program file (PGM), or on a control panel will not change the default
settings on the configuration pages.
For additional information about a page, click Help.
General Page
Display general information about the pump:
Fig. 9: General page

Device Type
Indicates the pump model.

Enable Virtual Mode
This check box should be cleared because Chromeleon only simulates the functions of the
pump when the virtual mode is active. If the
Virtual Mode is enabled, the Module
Address box will be unavailable.