Dionex ASE 150, Operator'S Manual

Page: 70 / 176

ASE 150 Operator’s Manual
62
Doc. 065207-02 9/08
Error 013 Clamp plate temperature high.
Cause: The heater cable connection to the power supply is loose, or a heater
component malfunctioned.
Action: Contact Dionex for assistance.
Error 014 Oven unable to reach temperature.
Cause: Incorrect settings of the oven voltage switches on the ASE 150 rear
panel.
Action: Set both oven voltage switches to match the voltage from the power
source at the installation site: either
110
(for voltages between 100
and 120 Vac) or
220
(for voltages between 220 and 240 Vac). For
details, see Section B.2.3 .
Cause: The heater cable connection to the power supply is loose, or a heater
component malfunctioned.
Action: Contact Dionex for assistance.
Error 015 Unable to rinse.
Cause: The pump could not deliver the specified rinse volume within the
allotted time. The cell or lines may be plugged.
Action: Run a rinse cycle (see Section 3.5 ). If the rinse runs without error, the
sample cell may be plugged. Replace the cell filter (see
Section 3.1.4 ) and the cell frit (see Section 5.2 ).
Action: If the rinse has the same error, there may be a blockage in the solvent
lines. Contact Dionex for assistance.