Dionex ASE 100, Operator'S Manual

Page: 66 / 150

ASE 100 Operator’s Manual
4-6
Doc. 031842-01 5/02
Error 013 Clamp plate temperature high.
Cause:
The heater cable connection to the power supply is loose, or a
heater component has malfunctioned.
Action:
Contact Dionex for assistance.
Error 014 Oven unable to reach temperature.
Cause: The heater cable connection to the power supply is loose, or
there is a problem with a heater component.
Action: The defective component should be replaced. Contact Dionex
for assistance.
Error 015 Unable to flush.
Cause:
The solvent bottle is empty, or is not properly installed.
Action:
Refill the solvent bottle, if necessary. Check that the solvent
bottle is installed as instructed in Section B.2.4.
Cause:
The pump could not deliver the specified flush volume within
the allotted time. The cell or lines may be plugged.
Action:
Run a rinse cycle (see Section 3.1.7). If the rinse runs
successfully, the extraction cell may be plugged. Replace the
cell filter (see Section 3.1.4) and the stainless steel cell frit (see
Section 5.1).
Action:
If the rinse is not successful, there may be a blockage in the
solvent lines. Contact Dionex for assistance.