INSTRUCTION’S MANUAL
Technical features
CARACTERISTICS
INSTALLATION
JUNCTION BOX
Antenna
* *
RF TIMER SWITCH FOR
Illuminated push buttons: maximum 20 units.
Unlimited non illuminated push buttons.
Timer switch incorporating a radio frequency receiver that
It works with our movement detectors references
D
M SEN R01,
D
M SEN R02 and
D
M SEN R03
with a maximum of 40 detectors.
The frequency used is 868,4 Mhz to avoid interference
problems. The signal is codified to be received only by the
required receivers.
Two hundred meters is the maximum distance to the
detectors in open field.
means it can be triggered with a radio signal as well as with
wired push buttons.
D
elay range adjustable with a potentiometer key from
30 seconds to 10 minutes.
This timer incorporates
an antenna which is
needed to work properly
and it must not be
manipulated.
Pushbutton
installation
an option
Tracon code:
MIPLAR01
Rated voltage:
230 V, 50 Hz
Switching capacity:
16 A, cos
φ
= 1
Incandescent lamps:
3.000 W
Fluorescent lamps:
1.300 W (130
μ
F)
:
18×7/12×11/10×15/10×20/10×23 W
CFL
Halogen lamps:
Own consumption:
40 mA
3.000 W
Time delay range
: 30 mp - 10 p
Resetting:
with new impulse
Detection range:
200 m in open field
Frequency:
868,4 MHz
Weight:
60 g
Operation temperature:
-10 - +45 °C
Working temperature:
-10 - +45 °C
Protection degree (housing):
IP20 (EN 60529)
Relevant standard:
EN 60669-2-1
WORKING
CODIFYING THE DETECTORS
CLEARING DETECTOR'S CODES FROM TIMER'S MEMORY.
Standard working function:
Potentiometer
Timer must be installed as shown in point
number 2 INSTALLATION. PUSH BUTTON.
PUSHBUTTON
POTENTIOMETER
It allows to adjust the time between
30 seconds and 10 minutes.
pressed. (Option).
soon as it receives a correct RF signal or when a wired push button is
diagram shown on point number 2, this will close its contacts as
Once the timer is connected to the mains according to the installation
If any of the detectors has low battery power, the timer will indicate it by
making the connected load (lamps) blink at the end of the
adjusted time.
The time will depend on the situation of the potentiometer key.
Once the timer is installed and helped by a pointed tool pressed
the indicated push button for 1 second.
From this moment and for
30 seconds, the timer pass to the learning codes mode and it is
indicated by a short blink of the load (lamps).
Switch ON the detector to be codified by placing the ON/OFF
selector in ON position (according to the Instruction's manual in
the detector).
Once the code is learnt, the timer will confirm it by making the
load (lamps) blink.
Once this is done, please switch OFF the detector by placing
the ON/OFF selector in OFF position (according to the
Instruction's manual in the detector).
Repeat the same process with all the required detectors.
Helped by a pointed tool keep the push button pressed for 4
seconds.
From this moment the timer enter into the clearing
codes mode.
With
this operation mode we clear from the
timer's memory all the detectors codes which it had in.
The memory is empty so the timer will recognise no signal
from any detector.
detector
s again
.
Once the timer finishes clearing all the codes it will indicate it
by making the load (lamps) blink twice and will return
automatically to the normal mode.
Once this is done, it will be necessary to codify all the required
EN
